Electrozad

Leviton® OSF10, integral occupancy sensor, is designed to be mounted directly into a luminaire. The OSF10 offers a sensor and relay in one device. The wiring and housing of the sensor is installed adjacent to the ballast and hidden from view behind the reflector cover. Only the PIR detector dome lens and locking ring are visible on the exterior of the fixture.

Leviton® Occupancy Sensor, Integral Luminaire, 120 to 277 VAC, 800/1200 VA Power, PIR Sensor, 10 ft Coverage, 30 s to 30 min Time Delay, 50/60 Hz Response, Fixture Mounting, 0 to 55 deg C, White

• Uses passive infrared technology to detect motion
• Time delay the time out occurs when motion is no longer detected by the sensor and the device counts a set amount of time before turning off the load
• If the device sensor detects motion during this 'time delay' the count resets and the device initiates a new count
• The time delay can be adjusted to 30 sec, 10, 20 and 30 min respectively
• Zero crossing circuitry relay uses a zero crossing circuitry to provide reliable, long life operation
• LED a red LED blinks when motion is detected
• Fresnel lens detects small motion when mounted within 6 ft of occupants
• When mounted at a height of 8 ft, the coverage will be approximately 10 ft diameter but sensitivity may be diminished
• The field of view below shows maximum coverage

• Technical Bulletin https://uat.south.electrozad.com//ASSETS/DOCUMENTS/ITEMS/EN/Leviton_ODC0P_W_Technical_Bulletin.pdf